Hello. I am hanging a mirror in my bathroom. It is a small mirror and I drilled holes in my wall to hang it.? - hanging bathroom mirrors
Unfortuntly I made a mistake and two holes about an inch by 1 / 2 low. Is it OK to drill two new holes so close together? Should I fill it with something else? The mirror is not really hard (one of the mirrors oscillating repulsive), but I'm not falling or unstable? Thank you for your help adance.
Wednesday, February 3, 2010
Hanging Bathroom Mirrors Hello. I Am Hanging A Mirror In My Bathroom. It Is A Small Mirror And I Drilled Holes In My Wall To Hang It.?
Subscribe to:
Post Comments (Atom)
3 comments:
At a vibrating mirror, I recommend having at least one screw into a hole. and yes, it's okay to fill the gaps, while new holes are at least 1 / 2 on.
If you do not jump into a hole stud wall, I would recommend using an anchor for drywall. This crushed behind the drywall, if you use a screw and provides a good fit. I want to make new holes at least 1 / 2 inch drill bit ... better, an inch away from the old holes. If you raise the mirror, only holes in old age, which is hidden from sight. If you have found on the mirror, you need to patch the holes, or your mistake is obvious. I say to be moved up and Customs!
Go to the hardware store and some Spackle. Fill the hole with putty delete the following addresses - sand and need to. then drill new holes. Not worry about looks? Go ahead and re-drill ... 1 / 2 inch should be good.
Post a Comment